Bellaform News, Bellaform GmbH, Pütz Prozessautomatisierung GmbH, Pütz Group, Prozessautomatisierung
Our systems
Good reasons for... Bellaform
For your products

Less contamination, longer service lives

by electrical monitoring of the pressure roll and cutting knife

Upon special customer request, Bellaform has developed and installed an electrical monitoring module that optimises the production process a little more once again.

We will gladly retrofit your existing Bellaform shear roller mixing system with this as well.


In order to prevent contamination and interferences in the production process, the pressure roll and cutting knives must not touch the granulation ring. An electrical circuit closes once the distance grows too small. It emits an optical signal with an
error message.

Notice: This equipment is only possible when processing non-conductive material.

Your success depends on reliable production. We are your experienced partners in this.

Overview of our service range:

  • Extrusion plants for smooth tubes up to ø 50 mm (mono- and multi-layered extrusion systems)
  • Control system (Bellex) with process data recording
  • Extrusion systems for corrugated pipes up to ø 58 mm
  • Shear roller mixing systems
  • Extrusion tools
  • Technical centre for test execution
  • Extruders
  • Used machines
  • Additional equipment
  • Service (shared product development, consulting, development, maintenance)


Thanks to our integration into the PÜTZ GROUP and the resulting synergy effects, we are able to offer you not just machines and systems for plastic processing, but also the appropriate test technology to test surfaces for dimensional accuracy


+49 6725 91925 0